Hi! It’s Steve from PartSelect. Today, we
are going to show you how to change the door handle on your refrigerator and it’s a really
easy job. All we are going to need is a very stiff putty knife and a Phillips screwdriver.
Let me show you how we do it. Now to change this handle we will need to remove the end
caps that cover the two screws in the top and two screws on the bottom that secure the
handle to the door panel. So with a stiff putty knife, we are just going to go into
the very edge of those trim pieces, and try to wiggle them away from the handle. Just
carefully pry up from the top one. Use caution that we don’t damage it. Once we have separated
it a bit from the edge of the handle, we can push at the rest away just with your thumbs,
and will slide it off. You will note that there is a couple of notches on that slide
into the back edge of that handle. So we will do the same thing on the bottom, and slide
it off and you will note that the two end caps are the same, so it doesn’t matter
which one we put on top or bottom. Next we will remove four Phillips screws that
hold the handle to the door panel and we can discard the old handle, and take note
that the handle does have a top and a bottom; bottom has a more gentle slope to it. So we
will begin by putting one of the screws in, just to hold it in place, and don’t tighten
the screws until we have all four in place. Now we can tighten them securely and then we will replace the end caps and
again, there are two tabs that will hook-in under the edge of the handle extension. Next
we will to make sure that they both engage with the end cap is pressed firmly against
the front panel, and then snap them into place and our repair is complete. I told you it
was an easy job. Thanks for watching and good luck with your repair.