repair clinic encourages you to perform
this procedure safely in this video we will show one or more of these icons to alert you when to use caution to make it easier to service the engine you may wish to position the snow blower
on its front and have a little or no gasoline in the
tank before you begin the repair make sure the engine has cooled turn off the fuel belt and remove the start key to replace the engines carburetor your
first step is to pull off the choke shaft knob next remove the screws to release the
upper snow shield disconnect the primer hose and the
start key wire harness to detach the shield now removed the screws to release the
lower snow shield and pull it off remove the screws securing the mounting
bracket and carburetor shield and pull them off now use pliers to release the clamp
securing the fuel inlet hose and pull the hose off be prepared for some gasoline to spill
out uninstall the bolt securing the carburetor remove the spring and throttle linkage and set the old carburetor aside now remove the screw securing the
starter motor’s gear cover and pull it off next use a thirteen millimeter socket
to remove the mounting bolts securing the starter motor and pull the motor off pull off the throttle knob remove the screw securing the control
panel and pull the panel off remove the bolts securing the gas tank and set the tank and cover aside you’re now ready to install the new
carburetor use the appropriate choke shaft choke
plate and primer tube that matches the configuration used by the old carburetor and assemble them on the new carburetor
according to the instructions depending on the condition and
application you can use the new or existing hardware during installation note the position of the old governor
spring then remove it install the appropriate new governor
spring in the same position as the old one replace the cover and the gas tank and secure them with the bolt reposition the control panel and secure it with the screw replace the throttle knob now position the motor on the engine and secure it with the bolts torque the bolts to manufacturers
specifications replace the gear cover on the blower
housing and secure it with the screw now align the shields isolator and the new carburetor on the
mounting bolts attach the spring and throttle linkage
to the carburetor and secure the assembly with the bolts torque the bolts to manufacturers
specifications connect the fuel inlet hose and secure it with the clamp replace the snow sheild bracket and the carburetor shield and secure the screws replace the lower snow shield and secure it with the screw connect the start key wire harness and
primer host to the upper snow shield reposition the shield secure the screws and slide the appropriate knob onto the
choke shaft with the new carburetor installed you
can now turn the fuel valve back on and return the start key to the engine